MS41 Live
ENFR
Request beta access
Documentation — Getting started

MS41 Live / Docs / Getting started

Getting started

From a stock Siemens MS41 to a first live session: what you need, the one full flash that installs the firmware, connecting the editor, and what to look at first.

Beta. MS41 Live has been developed and driven on one car (E39 523i, M52B25, manual gearbox). Read what is tested and what is not before you start, and keep the means to flash your original software back.

What you need

1. Save what is in the ECU

Before anything else, read the full contents of your ECU with your flashing tool and keep that file in a safe place. It is your way back to the original software.

2. Install the firmware: one full flash

MS41 Live comes as a full 256 KB image for each engine (firmware plus base tune) and as a 24 KB “partial” (calibration only). The first installation is a full flash of the image for your engine, with your flashing tool, on the bench or through the car.

3. Wire the sensors

By default the MAP sensor uses the Lambda 2 input (ECU pin 76) and the wideband the Lambda 1 input (pin 75). Both are 0–5 V inputs. The full description, with the warnings, is in Wiring; calibration is in Sensors & calibration.

4. Connect the editor

  1. Close any other program that uses the cable (diagnostic or logging software).
  2. Switch the ignition on. The engine may be stopped or idling.
  3. Open the editor file in Chrome or Edge and click Live: connect. The browser asks which serial port to use: pick the cable.
  4. The editor identifies the ECU. It refuses to work with an ECU that is not running MS41 Live.

You do not need a tune file to start: with no file open, connecting reads the calibration from the ECU, in about 40 seconds. You can also open a file first and connect afterwards.

Once connected, the gauges at the bottom update about six times per second and a cursor shows the table cell the engine is in.

5. The first live session

Engine off, ignition on

Engine running

6. Keep your changes

Live edits are in ECU RAM: they are lost when the ECU powers down. To keep them, stop the engine, leave the ignition on and use Flash partial: about 25 seconds. See Flashing. Save the tune file as well, with a new version name, so that you can always go back.

The ECU stays powered for a short while after the ignition is switched off. If you restart straight away, your live values may still be there. That is normal; after a real power-down the ECU is back on the flashed values.