Documentation — Flashing
Flashing
After the first installation, the calibration is flashed from the editor, through the same cable, in about 25 seconds. Only the 24 KB calibration (“partial”) is written from the browser.
Full flash and partial flash
| What it writes | How | When | |
|---|---|---|---|
| Full flash | Firmware and calibration (256 KB) | Your existing MS41 flashing tool, bench or OBD | The first installation, and any release that changes the firmware |
| Partial flash | Calibration only (24 KB) | The editor, in the browser | Every time you want to keep a tune |
A partial must match the firmware already in the ECU: flash partials made for the release you have installed. Checksums are corrected automatically, when you save a file and when you flash.
Before you flash
- Engine stopped, ignition on, editor connected (Live: connect).
- Laptop on mains power, car battery in good condition.
- Save the tune you are about to flash as a file, and keep the previous one.
- Keep your flashing tool at hand.
The sequence
Click Flash partial. The editor shows each step in a dialog with a progress bar and a log.
- Reading the ECU. The editor reads what is installed and shows it next to what you are about to write. Nothing has been changed yet; you confirm.
- Link test. The link is switched to flashing speed (62 500 baud) and tested. Nothing is erased until this test has passed. If the cable cannot hold that speed, the flash stops with the calibration intact, and the next attempts use a slower speed.
- Erase of the calibration area.
- Write, block by block. Each block is confirmed by the ECU before the next one is sent.
- Read-back. The whole calibration is read from the ECU and compared with your file.
- Key off. The editor asks you to switch the ignition off and tells you how long to wait.
- Key on, without starting. The ECU restarts on the new calibration, the editor checks its version and goes back to live mode.
For about 30 seconds, do not touch the ignition, the cable or the computer. Holding Shift while clicking Flash partial uses the slower speed from the start.
If a flash is interrupted
The dialog always says what state the ECU is in. The rules are simple.
The flash stopped before the erase
Nothing was changed. Switch the ignition off for 10 seconds, switch it back on, reconnect and start again.
The flash stopped during or after the erase — “flash incomplete”
- Keep the ignition on. Do not start the engine: the calibration is erased or incomplete.
- Check the cable, then press Resume flash. If the cable was unplugged, the editor asks for the serial port again. The missing blocks are written and everything is read back.
Resume is not possible
The ignition was switched off, the browser was closed, or the resume fails: switch the ignition off for 10 seconds, switch it on, reconnect and flash the partial again — from the editor, or with your flashing tool.
The read-back differs from the file
Do not start the engine. Switch the ignition off for 10 seconds, switch it on, reconnect and flash again.
Why keep your flashing tool. The editor only ever writes the calibration area; the firmware itself is never rewritten from the browser. If something goes wrong beyond what the editor can resume — or if you simply want the original software back — a full flash with your own tool is the fallback.
Reading the tune from the ECU
Read tune from ECU reads the flashed calibration through the cable, in about 40 seconds, and opens it in the editor. It reads what is flashed; values edited live since the last flash are in RAM, and the editor offers to take them if they differ.

